Mechanical Engineer by Profession, Flight Simulator Builder by Passion

Natural gas is one of the most important source of energy in the global energy market. It is a cleaner energy source compared to coal and...

The design goal was to create a unique architerctural structural combined to the SCADA system of an RMS Station (Natural gas Pressure...

Turkey's installed electrical power generation capacity increased up to 103.447 MWe (as of December 2022) The diversity of the generation...

Turkey's installed electrical power generation capacity increased up to 101.737 MWe. The diversity of the sources can be seen in the...

This is the bottom section of the HRSG, where the hot flue gases from gas turbine outlet flow through at approximately ~600oC. The coils...

Palmet Energy Group succesfully completed the acquisition of IZGAZ Izmit City Gas Distribution and Baymina Enerji A.Ş previously owned by...

Turkey's installed electrical power generation capacity increased up to 99.431 MWe. The diversity of the sources can be seen in the table below. I have also included a comparison between my last report (October 2020) and January 2022. The percentage of thermal power generation is %46.8 and for renewable sources the percentage is %53.2

Turkey's installed electrical power generation capacity increased up to 93.851 MWe. The diversity of the sources can be seen in the table...

One of my business development fields is the waste to energy sector. I have developed extensive know-how in waste solutions for a cleaner...

Time lapse video of an engine installation. The whole procedure takes about half a day + an other half day for the setttings within the...

This project is located in Ain Al-Sokhna - Egypt near the red see. This plant is the second biggest investment of our client in Egypt (The first plant is located in 6th of October near Cairo). Acting as the project manager, we designed, installed and commisioned the water based sprinkler systems (according to NFPA13), CO2 extinguishing systems, electronic detection and activation systems on an EPC basis

In this success story from the past, our client purchased an old factory building (approximately 6500 m2 land plot and 5000 m2 closed...

We are the main fire prevention and suppresion works contractor for the supply, design, implementation, commisioning and hand over to...

ALES power plant is located in Çine organized industrial zone , in Aydın city (located on the eagean cost of Turkey). It is a combined...

The GE (General Electric) LM6000 is a turboshaft aeroderivative gas turbine engine. The LM6000 is derived from the CF6-80C2 aircraft turbofan which is used in Boeing 747-400, McDonnell Douglas MD-11, Airbus A300 and Airbus A310 type airplanes. The declared performance data (as provided and published by GE) can be seen in the table below. For simple cycle operations; and for combined cycle in 1+1 configuration (ie. a single gas turbine + a single steam turbine) as follows, All

This fire fighting project is located in Faysalabad - Pakistan. This plant is the first investment of Hayat Group in Pakistan. Acting as the project manager we completed the installation and commisioing of the water based sprinkler systems (according to NFPA13), foam based extinguishing systems, CO2 based extinguishing systems with local applications, electronic fire detection and activation systems, underground hydrant lines and hose reel cabinet systems on a turnkey EPC bas

The PRS (pressure reduction station) for the Canadian gas grid is completed successfully in Gebze workshop in Turkey. As reported previously, the design maximum inlet pressure is 99.3 bars and the station outlet pressure is set at 5.5 bars range. The special design containerized, flexible PRS solution was done by Palmet group and the design was approved by Petra engineering of Canada (design according to CSA) The container was designed in such a way to work extreme low temper

We are currently manufacting a PRS (Natural gas pressure reduction station) which will have a maximum inlet pressure of 99.3 bars and an outlet pressure of 5.5 bars to be used in the Canadian gas grid. It will be a containerized flexible design which will be shipped from Turkey to Canada in a built package configuration. The design of the PRS (both the mechanical skid and the container) was done inhouse by Palmet Group and was approved and stamped by Petra Engineering of Cana

The project for the installation, commisioning and heat load testing for 20 nos. of 150 kW air-to-air cooling system (total of 3 MW cooling) has been successfully completed. The project is located in Ankara, Turkey in Kredi Kayıt Bürosu Tier4 datacenter. Palmet Engineering was the main contractor on an EPC basis of the complete phase-I of this huge datacenter complex. In phase one we have already installed 20 nos. of 150 kW cooling system for white space 1 and whitespace 2. T

Our project for the installation, commisioning and heat load testing for 20 nos. of 150 kW Air to Air cooling system has begun recently....